utFAT V1.0 - original version : http://www.uTasker.com/software/utFAT/utFAT1.0.zip
================================================================

utFAT V1.1 - 28.01.2010 : http://www.uTasker.com/software/utFAT/utFAT1.1.zip
=============================================================

  05.01.2010 Modify free cluster value written to info sector during formatting {1}
  19.01.2010 Reset file length when creating files to avoid taking values from previously deleted entres {2}
  20.01.2010 Add new time when writing to a file - add creation parameter to function fnSetTimeDate() {3}
  21.01.2010 Correction in fnAllocateCluster() which could cause FAT corruption on cluster growth {4}
  26.01.2010 Add SD controller interface                                 {5}
  27.01.2010 Correct creating, renaming and deleting files and directories in referenced sub-directories with help of flag UTDIR_SET_START {6}


utFAT V1.2 - 30.01.2010 : http://www.uTasker.com/software/utFAT/utFAT1.2.zip
=============================================================
  31.01.2010 Extend utOpenFile() mode parameter from unsigned char to unsigned short {8}
Note slight changes to interface - see references in the directory for http, ftp and command line interface

utFAT V1.3 - 16.02.2010 : http://www.uTasker.com/software/utFAT/utFAT1.3.zip
=============================================================
  02.02.2010 Don't allow a file to be renamed unless open for rename or write {9}
  02.02.2010 Don't allow a file to be written or deleted if it is read-only {10}
  08.02.2010 Ensure that the mass storage polling is terminated after each command that needed to wait {12}
  12.02.2010 Correct utReadFile() sector increment when end of file meets sector boundard {13}

utFAT V1.4 - 15.03.2010 : http://www.uTasker.com/software/utFAT/utFAT1.4.zip
=============================================================
  16.02.2010 Correct cluster counting when using info block as reference (move {4} to be generally used) {14}
  16.02.2010 Correct original FAT sector when allocating new clusters    {15}
  18.02.2010 Set directory back to lowest directory when the directory cluster end is exhausted {16}
  18.02.2010 Correctly extend directory clusters                         {17}

utFAT V1.5 - 30.03.2010 : http://www.uTasker.com/software/utFAT/utFAT1.5.zip
=============================================================
  19.03.2010 Add force of sector load rather than a transfer to a buffer {18}
  29.03.2010 Add fnGetLocalFileTime() to allow file data/time stamps to be returned by systems with corresponding support {19}
  30.03.2010 Block reformat when the disk is write protected and clear disk state when starting {20}

utFAT V1.6 - 18.09.2010 : http://www.uTasker.com/software/utFAT/utFAT1.6.zip
=============================================================
  09.04.2010 First version of MANAGED_FILES support including delete control {21}
  14.06.2010 Add fnWriteSector()                                         {22}
  06.07.2010 utReadDirectory() made extern                               {23}
  30.07.2010 Optimised local routines to avoid reading partial data when not necessary - simplifies and improves compatibility with SD controller operation
  04.08.2010 Move various defines from here to mass_storage.h
  06.08.2010 Introduce SDCARD_MALLOC() macro to better control the malloc() area used {24}
  16.09.2010 Ensure that root-referenced paths work with correct location {25}
  16.09.2010 Ensure that the public disk location entry can not be used uninitialised {26}

Note slight changes to interface - see references in the directory for http, ftp and command line interface
Modification to SD card simulator to support SD card controller interface - see SDcard_sim.c


utFAT V1.7 - 08.10.2010 : http://www.uTasker.com/software/utFAT/utFAT1.7.zip
=============================================================
  24.09.2010 Change ucDiskFlags to usDiskFlags and add DISK_NOT_PRESENT when no disk detected and DISK_TYPE_NOT_SUPPORTED when non-supported type {27}
  25.09.2010 Add uMatchFileExtension()                                   {28}

utFAT V1.8 - 05.01.2011 : http://www.uTasker.com/software/utFAT/utFAT1.8.zip
=============================================================
  17.10.2010 Add NAND Flash support                                      {29}

utFAT V1.9 - 02.03.2011 : http://www.uTasker.com/software/utFAT/utFAT1.9.zip
=============================================================
  17.02.2011 Copy volume label when a disk is mounted                    {30}
  21.02.2011 Cast DIR_NAME_FREE comparison                               {31}
  24.02.2011 Add UTFAT16 support                                         {32}
  24.02.2011 Add support for full formatting (including data section) and formatting flags {33}
  25.02.2011 Block any write actions when the disk is write protected and allow use to select how the WP switch is read {34}


utFAT V1.10 - 24.08.2011 : http://www.uTasker.com/software/utFAT/utFAT1.10.zip
===============================================================
    20.08.2011 Correct cluster allocation over sector boundaries         {35}
    20.08.2011 Correct big-endian cluster deletion                       {36}
    24.08.2011 Recognise empty file names and reject them                {37}
    24.08.2011 FAT16 cluster corrections                                 {38}

utFAT V1.11 - 19.01.2012 : http://www.uTasker.com/software/utFAT/utFAT1.11.zip
===============================================================
    17.09.2011 Allow UTFAT_APPEND attribute to set the file pointer straight to the end of the file when opening for write {39}
    18.01.2012 Allow operation without UTMANAGED_FILE_COUNT and/or without UTFAT_WRITE {40}
    18.01.2012 Enable debug output to be disabled with UTFAT_DISABLE_DEBUG_OUT {41}
    18.01.2012 Allow fnRunThroughClusters() to return error value and limit forward seek to end of file {42}

utFAT V1.12 - 05.08.2012 : http://www.uTasker.com/software/utFAT/utFAT1.12.zip
===============================================================
    20.01.2012 Remove some unused variables when no UTFAT_WRITE/UTMANAGED_FILE_COUNT operation {43}
    28.01.2012 Add LFN length protection                                 {44}
    28.02.2012 Add LFN delete support                                    {45}
    06.03.2012 Don't delete file content cluster chains when they don't exist {46}
    21.03.2012 Allow directory paths aaa\bbb\ terminated with \          {47}
    02.04.2012 Add utServer()                                            {48}
    02.04.2012 Add SD card simulation display interface                  {49}
    02.04.2012 Add card removal monitoring                               {50}
    27.07.2012 Improve return result from ut_read_disk() to include errors {51}
    27.07.2012 Add card detection input polling and interrupt modes      {52} - see http://www.utasker.com/forum/index.php?topic=1747.msg6270#msg6270
    05.08.2012 Card removal monitoring based on checking card modified to read last section {53}


