Show Posts
1
µTasker general / Web to Firmware Communication
« on: November 21, 2008, 10:04:00 PM »
Hello All,
I am using the the coldfire m52233demo board and have installed the utasker software, and have been able to successfully upload a web interface onto the board and browse to it. My question is how are variables passed from the web interface to the firmware and vice versa. I have read a about using "£" as a prefix. I have a module written in C which will get the current temperature now I just want to display it to the web page how is this accomplished.
I am using the the coldfire m52233demo board and have installed the utasker software, and have been able to successfully upload a web interface onto the board and browse to it. My question is how are variables passed from the web interface to the firmware and vice versa. I have read a about using "£" as a prefix. I have a module written in C which will get the current temperature now I just want to display it to the web page how is this accomplished.