µTasker Forum
µTasker Forum => NXPTM M522XX, KINETIS and i.MX RT => Topic started by: tdrobnak on June 27, 2019, 09:43:38 PM
-
Does someone know how to add more special function registers (SFRs) to the MCUXpresso "Peripherals+" view when the uTasker configuration is used? When I debug I get three SFRs: DCR and NVIC, but when I debug with a project generated by an MCUXpresso SDK wizard I get all the SFRs.
-
Hi
I suspect that the exact processor type being used is not configured and then the peripherals that the chip would have are not know to the IDE.
If you can find where the processor type is configured (rather than just Cortex-m0+ or Cortex-m4 core) it will likely show the peripheral registers too.
Good luck
Regards
Mark
-
Hi Mark,
Thank you so much for that information. You are correct, it was the processor setting. I went into the Properties for the uTasker project and changed the C/C++ Build->MCU settings processor from Preinstalled MCUs "Generic-M0plus" to SDK MCUs "MKE15Z256xx7". When I started a new Debug session, All of the registers that were shown in the SDK wizard generated program show up in the uTasker project.