16
µTasker general / Re: uTaskerConvert problems
« on: December 31, 2019, 05:05:25 AM »ok, thanks.
Nov 2020: uTasker i.MX RT V1.4.12 is productive - with complete secure loading concept.
Follow uTasker updates at www.twitter.com/uTasker !!
Online Forum registration has now been disabled. Please send an email to an address at the bottom of the home page with your preferred user name and email address if you would like an account.
Return to uTasker main site: www.utasker.com
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
5. For SD card operation share the setup with other boards alreadiy using the SD card controller:
#if defined STM3240G_EVAL || defined ST_MB997A_DISCOVERY || defined STM32F746G_DISCO
#define SD_CONTROLLER_AVAILABLE // use SDIO rather than SPI (necessary on STM3240G-EVAL board)
#if !defined TWR_K20D50M && !defined FRDM_K20D50M && !defined FRDM_KL46Z && !defined FRDM_KL43Z && !defined TWR_KL46Z48M && !defined FRDM_KL26Z && !defined FRDM_KL27Z && !defined TWR_KL25Z48M && !defined FRDM_KL02Z && !defined FRDM_KL03Z && !defined FRDM_KL05Z && !defined FRDM_KE02Z && !defined FRDM_KE02Z40M && !defined FRDM_KE04Z && !defined TWR_K20D72M && !defined TWR_K21D50M && !defined TWR_K22F120M && !defined TWR_K24F120M && !defined K24FN1M0_120 && !defined FRDM_K22F && !defined TWR_KV10Z32 && !defined TWR_KV31F120M && !defined K66FX1M0 // boards have no SD card socket
//#define SDCARD_SUPPORT // SD-card interface (only choose one of these options at a time)
//#define SPI_FLASH_FAT // SPI flash
#define SIMPLE_FLASH // don't perform block management and wear-levelling
#define FLASH_FAT_MANAGEMENT_ADDRESS (SIZE_OF_FLASH)
//#define DELETE_SDCARD_FILE_AFTER_UPDATE
//#define SDCARD_SUPPORT // SD-card interface (only choose one of these options at a time)
//#define SPI_FLASH_FAT // SPI flash
#define SIMPLE_FLASH // don't perform block management and wear-levelling
#define FLASH_FAT_MANAGEMENT_ADDRESS (SIZE_OF_FLASH)
Hi
Are you using the open source version on GITHUB or the professional version?
Regards
Mark