Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hossain

Pages: [1]
1
µTasker general / Re: Using TCP in the uTasker project
« on: May 29, 2010, 10:17:12 AM »
OK, i think A successfully sent message can also fail to arrive at the destination due to a transmission error for example - it may arrive too but the ack could get lost instead. In this case the transmission should be retried after TCP has detected the timeout - or after ARP has resolved the destination IP address.
thanks

Pages: [1]