1
µTasker general / How to view debug messages on the uTasker Simulator
« on: November 29, 2022, 12:33:13 AM »
Hello! I am getting started with uTasker and got stuck when trying to simulate debug messages sent over UART. I've been following the guide at https://www.utasker.com/docs/uTasker/uTaskerV1.4_user_guide.PDF and got to the point of actually seeing the "Hello Worlds" when running the project on my FRDM-K64F through a serial monitor on my PC. However, when running the simulator I see at the bottom that the UART0 is mapped to the COM 4, but there is no COM Port showing up in my device manager and I could not connect to it using a serial monitor.
Do you know how I could see these messages sent over UART? Am I supposed to be doing something differently?
Thank you for your help! I am still learning about embedded systems at university and found the uTasker project super interesting.
Do you know how I could see these messages sent over UART? Am I supposed to be doing something differently?
Thank you for your help! I am still learning about embedded systems at university and found the uTasker project super interesting.