µTasker Forum
µTasker Forum => utFAT => Topic started by: neil on September 17, 2011, 07:31:54 PM
-
Hi Mark,
My latest version of the uFat is "24.08.2011 FAT16 cluster corrections " , can I simply copy the 3 files dated "utFAT V1.10 - 24.08.2011" into my project without any issues?
Thanks
Neil
-
Hi Neil
It should be possible to simply overwrite the three files.
However it is best to make a backup of the original ones, recompile with the new ones and then verify that all builds normally. If it builds it means that there are no basic incompatibilities - I would then expect the actual operation to be OK (with additional features and/or corrections).
In case of build errors it may be that some parameters changed along the way which need adapting in the application also - newer versions of the project will show what is required (if an older basis is used to start with).
Regards
Mark