Thanks for this great resource. I've been able to do quite a bit with it so far. Now I'd like to communicate with the UARTs and I'd like to start with the simulator.
I've tried following the section on UARTS in the Simulator in post
http://www.utasker.com/forum/index.php?topic=54.0 but I'm not having any luck. There is also a reference to a different tutorial in the LM3SXXXX tutorial that I can't seem to find.
My computer only has 1 serial port so I'm setting to port 3 as below then building the Simulator and trying to access the simulator using the serial port of another computer. Is this correct?
At first, I thought I could open a terminal window on the same computer but after thinking about it, I figured I'd need to use a second computer. I confirmed that I can talk between the two computers by sending messages back and forth between terminal sessions on each computer.
Any ideas?
Thanks,
TW
#define SERIAL_PORT_0 '3' // if we open UART channel 0 we simulate using this com port on the PC (0 for no mapping)
#define SERIAL_PORT_1 '3' // if we open UART channel 1 we simulate using this com port on the PC
#define SERIAL_PORT_2 '0' // if we open UART channel 2 we simulate using this com port on the PC