So I am attempting to move my MCF53325 project from CW 7.2 to 10.2. After performing the import as described in another
forum (
http://www.utasker.com/forum/index.php?topic=1310.0) and documents on the uTasker site and making a few (OK,
many) adjustments to paths, etc. I have gotten everything to compile/link and load, but I then realized had made a mistake
in which .LCF file I was using in the project.
The project I had compiled for the ColfFire main uTasker was intended (memory-wise) to be part of a 'full' system that includes
both of the uTasker boot loaders. Thus I used the M52235_BOOT_APP_FLASH_SPI.LCF file where the start location of the
main application code is well past 0x00000000 (0x00004000). When I realized this I changed the .LCF to the correct one
(M52235_FLASH.LCF) which starts at 0x00000000.
After this change, I spent the last 3 hours attempting to get the project to actually use this new starting address when it
actually flashes the ColdFire. I have changed all .LCF file references to the correct one and the flash tool still erases starting at 0x000040000
and then proceeds to flash the MCU starting there.
So what am I missing. I have looked through all the various settings and they all seem correct...at least the ones I looked at.
Does anyone (Mark?) know where I might find this and change it. I believe this should be easy, but as of yet, this is NOT
the case.
Thanks much.
- jon