µTasker Forum
µTasker Forum => NXPTM M522XX, KINETIS and i.MX RT => Topic started by: tr111 on February 28, 2008, 12:53:21 PM
-
I want to use the c++ file and use the "class".but in the cw6.4 is always error when I add the *.cpp file????
How can I do!
-
Hi
This is specific to CW and I don't have an answer because uTasker uses only C (not C++).
However the CW compiler seems to also to support C++ - I would check the language settings in the project configuration since there are a few C++ settings there.
Otherwise try asking at the following Freescale forum:
http://forums.freescale.com/freescale/board?board.id=CWCFCOMM
Regards
Mark