Hi, I'm using the uTasker 1.4 project for a 52259 EVB board. After some time with the simulator, and successfully trying most of the proyect features, I decided to start with the actual target board. The question is about UART interrupts not being generated and how to debug this problem.
Using CW, I tried setting a breakpoint in _SCI1_Interrupt but nothing happens when the character is received, however the breakpoint is hit every 10 seconds when the Async routine I wrote is scheduled, and I just get two bytes from the UART using fn. The rest of the information is lost.
Transmission works fine, every time I send out a byte the breakpoint is hit and I see the data at the hyperterm at 9600baud. I also tried UART0 and UART2 with similar results.
I'm sure I'm missing something, but I can't figure it out, any help is greatly appreciated.
Elio Mussini