µTasker Forum

µTasker Forum => µTasker general => Topic started by: Kyle Mercer on October 24, 2017, 04:39:44 PM

Title: 1-Wire Protocol
Post by: Kyle Mercer on October 24, 2017, 04:39:44 PM

Is there any out of the box support in uTasker for communicating with Maxim (Dallas Semiconductor) 1-Wire devices? If not, has anyone managed to successfully add this protocol to their uTasker based device (preferably Kinetis)?

Title: Re: 1-Wire Protocol
Post by: mark on October 24, 2017, 08:45:31 PM

Kyle

I don't have anything for 1-wire. Is it normally bit-banged?

Regards

Mark

Title: Re: 1-Wire Protocol
Post by: Kyle Mercer on October 24, 2017, 09:02:05 PM

Bit banging is one way to communicate. A UART/USART can also be used as a 1-wire master or there are 1-wire master ICs that communicate via I2C or SPI.