µTasker Forum
µTasker Forum => µTasker general => Topic started by: tyler on November 21, 2008, 10:04:00 PM
-
Hello All,
I am using the the coldfire m52233demo board and have installed the utasker software, and have been able to successfully upload a web interface onto the board and browse to it. My question is how are variables passed from the web interface to the firmware and vice versa. I have read a about using "£" as a prefix. I have a module written in C which will get the current temperature now I just want to display it to the web page how is this accomplished.
-
Hi Tyler
There is a quick overview in the following post which should help:
http://www.utasker.com/forum/index.php?topic=94.0
regards
Mark