Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - PunKidd

Pages: [1]
1
Oops.  I must have misunderstood something you said in the other thread about the supported controller ICs when I was picking a display & driver.

I think I'll just work on wiring it up to the flex bus for the time being.

Thanks!

2
I feel like I'm missing something obvious here.  I'm connecting a display that uses the SSD2119 driver IC that is used in the tower GLCD module.  I'm connecting it to a M52259EVB board via SPI.  I see where to configure the data and control pins for parallel bus mode, but where can I configure the SPI when using serial mode?  I want to set it up so the last CS is used for the display so I can have flash on the first 3 chip selects. 

Any nudge in the right direction is appreciated.  Thanks!

Pages: [1]