1
ATMELTM AT91SAM7X and AVR32 / Re: Unable to configure correctly Rowley SAM7-EX Board (uTasker SP3)
« on: November 28, 2008, 05:14:26 AM »
Hello everyone, just wanted to give closure to this post.
I've managed to run uTasker on my board after somework, however, Ethernet is still unable to function, Mark has helped me a lot on this issue, and we are almost to the conclusion that the board's PHY is fauilty. Every other tested function in the board seems fine, but all depending on the ethernet port have failed.
I've installed the simulator on an XP machine and everything worked fine...
Hopefully I can get another board, however it will most likely be too late for my final projects, which ill just simulate in order to present it. If by any chance I manage to make the board work, I will post what was wrong, because it's still a posibility that the PHY could have differences from other boards.
Thanks again.
Javier
I've managed to run uTasker on my board after somework, however, Ethernet is still unable to function, Mark has helped me a lot on this issue, and we are almost to the conclusion that the board's PHY is fauilty. Every other tested function in the board seems fine, but all depending on the ethernet port have failed.
I've installed the simulator on an XP machine and everything worked fine...
Hopefully I can get another board, however it will most likely be too late for my final projects, which ill just simulate in order to present it. If by any chance I manage to make the board work, I will post what was wrong, because it's still a posibility that the PHY could have differences from other boards.
Thanks again.
Javier