µTasker Forum

µTasker Forum => µTasker general => Topic started by: hervé on October 11, 2011, 02:54:58 PM

Title: 1UserFiles.bin
Post by: hervé on October 11, 2011, 02:54:58 PM
Hello Mark,


When using the 1UserFiles.bin for web interface, the file is loaded at address corresponding to the '1' : what about the address of the '0' file, it is not used ?
Why don't loading at 0UserFiles.bin ? (and changing fnActivateEmbeddedUserFiles to look at it)

Thanks
Title: Re: 1UserFiles.bin
Post by: mark on October 11, 2011, 03:19:31 PM
Hi Hervé

There is no specific reason for the file to be located at position '1'. It could be at any position and, if it is the only file to be loaded, it also makes sense to use '0'. [I think that the location '1' was used for illustrative purpose, or for a test, and was left there].

In some cases it may also be an idea to locate it towards the end of the file system so that there is space for some other, smaller files at the start.

Regards

Mark