µTasker Forum

µTasker Forum => µTasker general => Topic started by: mark on December 31, 2011, 11:16:12 PM

Title: CAN and CAN Simulator
Post by: mark on December 31, 2011, 11:16:12 PM
Hi All

As closing development for 2011 I have just managed to complete the Dual FlexCAN driver for the Kinetis project. There has been a CAN driver in the Coldfire project for a long time (single CAN interface) and this additional has also allowed the integration of a new standard CAN simulation technique using a CAN bus analyser called the KOMODOTM CAN DUO from TOTAL PHASE http://www.totalphase.com/products/komodo_canduo/

This is described in the revised CAN driver documentation: http://www.utasker.com/docs/uTasker/uTaskerCAN.PDF
and demonstrated in the video guide: http://youtu.be/Ha8cv_XEvco

Regards

Mark

Title: Re: CAN and CAN Simulator
Post by: mark on February 20, 2012, 01:42:10 AM
Hi All

Many thanks to Kelly at TOTAL PHASE for linking back to the CAN demo!!

See the blog entry at http://blog.totalphase.com/blog/2012/01/watch-utasker-and-the-komodo-interface-in-action/

Regards

Mark