µTasker Forum

µTasker Forum => NXP^TM M522XX, KINETIS and i.MX RT => Topic started by: mark on January 17, 2017, 05:28:48 PM

Title: KDS 3.2 Debug Difficulties when low power operation is enabled
Post by: mark on January 17, 2017, 05:28:48 PM

Hi All

KDS3.2 debugging has not been reliable (hardly possible) when SUPPORT_LOW_POWER is defined.

To solve this (rather than disable the low power operation) use the "Check for Updates" command in the KDS Help menu and then allow it to install a newer version of "GNU PEMicro Interface Debugging Support".

After installing this (and optionally other updates) KDS needs to be restarted.

Then debugging works normally again!!

Regards

Mark