Show Posts
1
µTasker general / debug/programming - opensda jlink/pemicro?
« on: April 12, 2016, 08:56:56 PM »
Hi There,
I am just getting started with utasker for experimentation. I am able to successfully build a project in KDS, but am wondering what the most direct way to debug/flash the board is? The quickstart instructions video is for codewarrior and uses the flash utility which is not a part of KDS nor can it debug.
Is it possible to easily use the opensda jlink or pemicro debuggers on the freedom boards? If so how do I configure this?
Thanks!
Update: After doing some experimenting I found it to be quite simple. Go into "debug configurations" and add a "New" configuration under "GDB SEGGER J-link Debugging". The only parameter I had to add was "MK22FN512xxx12" under "device name" in debugger settings. It seems to be working well enough.
I am just getting started with utasker for experimentation. I am able to successfully build a project in KDS, but am wondering what the most direct way to debug/flash the board is? The quickstart instructions video is for codewarrior and uses the flash utility which is not a part of KDS nor can it debug.
Is it possible to easily use the opensda jlink or pemicro debuggers on the freedom boards? If so how do I configure this?
Thanks!
Update: After doing some experimenting I found it to be quite simple. Go into "debug configurations" and add a "New" configuration under "GDB SEGGER J-link Debugging". The only parameter I had to add was "MK22FN512xxx12" under "device name" in debugger settings. It seems to be working well enough.