Messages

1

Freescale^TM MC9S12NE64 / Re: MC9S12NE64 SCI port and Interrupts

« on: March 31, 2009, 11:10:19 AM »

Hi Mark,
Thanks for the reply.
I read the thread and reread the uTaskerDrivers document that came with uTasker and I'm still having difficulties.
I tried setting the QUEUE_HANDLE configurations in application.c but the SCI didn't work. Also, I tried copying the SCI example in the uTaskerDrivers document in application with no luck and into my own program and again with no luck.
Can you please tell me how to configure and enable SCI1 and set set the message length for MSG_MODE?
Thanks

2

Freescale^TM MC9S12NE64 / MC9S12NE64 SCI port and Interrupts

« on: March 26, 2009, 05:47:12 AM »

Hello,
I'm using the neCore to recieve and sort ID numbers(in ASCII) from a RFID reader. I've initialized ports and used interrupts before in assembly but not in C. Also, I was wondering how uTasker deals with interrupts, I found the SCI 1 interrupt but I'm not sure on how to use it.
Any help will be greatly appriciated.
Regards,
M Koleed

3

µTasker general / Processor Expert

« on: February 19, 2009, 10:01:56 AM »

Hi,
I'm using the neCore12 with the MC9S12NE64 and was wondering if Processor Expert and uTasker have the same header files because I wanted to use Processor Expert to initialize some of my ports?
Thanks