Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - RichardV

Pages: [1]
1
Disregard....

I got it working! Thanks so much for the assistance Mark!

2
Thanks for the reply Mark!

would these added lines go in the config.h file for the Serial Loader build? Just want to make sure.

3
I got the Serial Loader for teensy3.5 working but it requires the loader to start first before it will read the new software off of the SD Card. Is there a setting within the Serial Loader build process to have the Serial Loader start at power up every time?

My existing project with Teensy3.5 won't allow me to have specific pins pulled low or high at boot so I was wondering if there was a mechanism in the Serial Loader build process to just always have it boot and pull in the current the rev of software that will be residing on the SD Card?

4
Then for now I think I'll just stick with trying to build the SerialLoader with USB drop and drag from PC and SD Card loading. I tried this the other day but looks like it didn't take so going to have to revisit what I did wrong.

5
....and reasoning for wolfSSL is that government likes to see FIPS-140 compliance and wolfSSL stays current with those qualifications

6
Mark,
So if I have the education/hobby non-commercial license AES256 is not included?

7
I'm very new uTasker Serial Bootloader. I've been working with Teensy products for some time though. I would like to be able to take advantage of the wolfSSL encryption libraries and did notice that they are part of the uTasker project. Is there a chance I could get some guidance on the setting up the Serial Bootloader for Teensy3_5 to provide only the following:

1. Serial Bootloader with SD CARD and USB Thumbdrive loader support
2. AES encryption w/ wolfSSL integration.

Pages: [1]