Messages

16

µTasker general / Re: USB not supported

« on: April 05, 2016, 06:41:34 PM »

The LED is blinking, that means it´s in bootloader mode. My computer make a beep, that means computer enum the device but it´s not working well.

17

µTasker general / Re: USB not supported

« on: April 05, 2016, 06:26:36 PM »

I add the pics of the configurations.
I´m using the jumper J18 in ON mode.
I installed the .inf drivers in ".....uTaskerKinetisV1.4.7\Applications\uTaskerV1.4\USB"

18

µTasker general / Re: USB not supported

« on: April 05, 2016, 05:46:14 PM »

I also noted that in the app_hw_kinetis and other documents you are using #include "config.h" and this are not enabling the macros. Instead of that I used #include <config.h> and this enable the macros required in CW.

19

µTasker general / Re: USB not supported

« on: April 05, 2016, 05:36:22 PM »

Good morning Mark:

I'm trying to unzip the uTasker Kinetis V1.4.11 and I can't do it, a password is required.

Regards.

20

µTasker general / USB not supported

« on: April 04, 2016, 11:58:21 PM »

hello!

I would like to know why the USB communication it's no supported in the mode I configured the uTasker?.
I followed all the instructions.
i attached the document.

I'll be thankful for your help.
Regards!