µTasker Forum > NXP^TM LPC2XXX and LPC17XX

New Task adding Error in USB MassstorageMa

(1/1)

Manish:
Hi Mark,  
     After getting your  USB masstorage source code , while we add a new task in Taskconfig.h,  program does not start and same a when remove those added task then again USB massstorage code run again. so can you please check it. We use LPC23xx LPC2388 v1.4 with MCI sdcard.

Thanks
Manish DAbhi

mark:
Hi

Have you tried the latest project version with USB_INTERFACE enabled?

When adding new code to general projects make sure that there is enough heap available for the USB interface since a uMalloc() failure would mean that the code can not run.

Regards

Mark

Navigation

[0] Message Index