µTasker Forum > µTasker general

FRDM-K64F FTP

(1/1)

carlos789:
Hello:
I am using the uTaskerV1.4.8_FRDM-K64F_LAN.bin binary on a FRDM-K64F board, I want to load the web pages using an FTP connection with copy_all.bat, I get the following message:

conectado a 192.168.0.3 .
 
220 Welcome KINECTIS FTP.

And the HTM file transfers are never displayed.
What am I doing wrong?
I would appreciate if you can guide me with the solution.
Thank you very much and greetings
carlos789

mark:
Hi

The bat file that does this just needs to be double clicked and therefore it is not possible to do anything wrong with the action itself.

However you may have a firewall issue that is allowing the FTP command connection to be established but not the FTP data connection.
Try recording the Ethernet activity with wireshark to see what actually happens and also try temporarily disabling and firewall that you have.

Regards

Mark

Navigation

[0] Message Index