Hello all,
I have an LCD module TM240320B9NFWUGWC and it has inbuilt ILI9325
controller.
MPU-Interface Mode is through 8-bit parallel interface.
I'm trying to read its device code but its not working, I always
getting 0x0000. If any body can help on this, that will be very
appreciated.
My code is as follow
------------------------------------------------------------------
void TSLCDInit(void) //initial LCD
{
TSLCDOutIns(TS_INS_START_OSC);
driver_code = TSLCDInDat();
if (driver_code == 0x9320) //ILI9320
{
TSLCDInit9320();
}
else if (driver_code == 0x9325) //ILI9325
{
TSLCDInit9325();
}
}
--------------------------------------------------------------------
But I am getting driver_code = 0x0000
And my write command, write data and read data as follow
void TSLCDOutIns(unsigned short ins) //write instruction to LCD
{
LPC_PINCON->PINSEL0 &= ~(0xFFFF<<4);
LPC_GPIO0->FIODIR |= LCD_DATA_MASK;
LCD_CS_LOW();
LCD_RS_LOW();
LCD_RD_HIGH();
LCD_WR_HIGH();
LCD_WR_LOW();
delay_ms(1);
LPC_GPIO0->FIOPIN &= ~LCD_DATA_MASK;
LCD_WR_HIGH();
LCD_WR_LOW();
delay_ms(1);
LPC_GPIO0->FIOPIN |= ins<<2;
LCD_WR_HIGH();
delay_ms(1);
}
void TSLCDOutDat(unsigned short dat) //write data to LCD
{
LCD_RS_HIGH();
LCD_RD_HIGH();
LCD_WR_LOW();
LPC_PINCON->PINSEL0 &= ~(0xFFFF<<4);
LPC_GPIO0->FIODIR |= LCD_DATA_MASK;
LPC_GPIO0->FIOCLR = LCD_DATA_MASK;
LPC_GPIO0->FIOSET = (dat >> 8 ) << 2;
LCD_CS_LOW();
LCD_CS_HIGH();
LPC_GPIO0->FIOCLR = LCD_DATA_MASK;
LPC_GPIO0->FIOSET = dat << 2;
LCD_CS_LOW();
LCD_CS_HIGH();
LCD_WR_HIGH();
LPC_PINCON->PINSEL0 &= ~(0xFFFF<<4);
LPC_GPIO0->FIODIR &= ~LCD_DATA_MASK;
}
unsigned short TSLCDInDat(void) //read data from LCD
{
unsigned short retval = 0;
LPC_PINCON->PINSEL0 &= ~(0xFFFF<<4);
LPC_GPIO0->FIODIR &= ~LCD_DATA_MASK;
LCD_CS_LOW();
LCD_RS_HIGH();
LCD_RD_LOW();
delay_ms(1);
retval = (LPC_GPIO0->FIOPIN & LCD_DATA_MASK);
LCD_RD_HIGH();
delay_ms(1);
LCD_RD_LOW();
delay_ms(1);
retval = (retval << 8 ) | (LPC_GPIO0->FIOPIN & LCD_DATA_MASK);
LCD_RD_HIGH();
delay_ms(1);
LCD_CS_HIGH();
return retval;
}
Note: For data lines I am using P0.2 to P0.9 and that's why I am
shifting 'ins' and 'dat' left by 2.
-Prakash
9886545216