1
NXPTM M522XX, KINETIS and i.MX RT / Re: Getting Started With a Custom PCB
« on: March 15, 2019, 06:45:43 AM »
Thanks for the info. I have updated the code per your recommendations.
Am I going to run into any issues by defining the pin count as 80 and package type as LQFP as shown in the attachment? Just want to double-check on this before I go too far with the K60 setup. It doesn't appear to be a valid HW configuration, but I'm not sure if those dependencies are built into the serial loader code or not.
Thanks.
Am I going to run into any issues by defining the pin count as 80 and package type as LQFP as shown in the attachment? Just want to double-check on this before I go too far with the K60 setup. It doesn't appear to be a valid HW configuration, but I'm not sure if those dependencies are built into the serial loader code or not.
Thanks.