Hi Mark:
Thanks for the reply, the settings where ok...
The problem is when i try to change the IP direction in line 426 of application.c... It does not matter what i put there, it preserves the IP address i previously set in the first time... for exmaple, i first set the ip to 192.168.0.3... Everything worked perfect, then in KDS i set the ip address 192.168.0.2, but the device is still responding to 192.168.0.3... if i erase the device with uVision IDE (it has a button for that), then i can set the ip i want... but fron KDS apparently the flash is not being correcly erased... Do you know why this may happen?
Previously, the device was configured with a not valid subnet mask and ip address, but to change it i had to erase the device with uVision... it would be nice if i could do that from KDS, perhaps some settings are wrong, but i can't figure out which
Thanks