1
NXPTM M522XX, KINETIS and i.MX RT / Re: How to configure to meet for TRK-KEA8?
« on: July 10, 2019, 04:53:39 AM »
Thanks the help, here is my following question
1. if no KEA_8_1_BM, assume we can only use KEA_8_1 for uTaskerV1.4_BM.elf build also.
2. for feature disable, I started to look config.h, I just enable BLINKY and HELLO_WORLD, now build for KEA8 succeed. but the ustaker for KEA8 (refer the attached ) is different with http://www.utasker.com/kinetis/TRK-KEA8.html. the difference is ustasker in my PC have 6 ADC lines, but picture in web don't have 6 ADC lines? And we can see the hint in the uTasker simulater status bar is "FLASH= 64K", assume it should be 8K.
3. I did not find how to use serial port? assume we need a tool or telnet/secure CRT to connect to serial port of uTasker Simulator(which is running in Windows )
4. when for TRK-KEA1288, Hardware\Kinetis\kinetisSim.c , PI_0_UART2_RX/PI_1_UART2_TX undefined error happen
Thanks
1. if no KEA_8_1_BM, assume we can only use KEA_8_1 for uTaskerV1.4_BM.elf build also.
2. for feature disable, I started to look config.h, I just enable BLINKY and HELLO_WORLD, now build for KEA8 succeed. but the ustaker for KEA8 (refer the attached ) is different with http://www.utasker.com/kinetis/TRK-KEA8.html. the difference is ustasker in my PC have 6 ADC lines, but picture in web don't have 6 ADC lines? And we can see the hint in the uTasker simulater status bar is "FLASH= 64K", assume it should be 8K.
3. I did not find how to use serial port? assume we need a tool or telnet/secure CRT to connect to serial port of uTasker Simulator(which is running in Windows )
4. when for TRK-KEA1288, Hardware\Kinetis\kinetisSim.c , PI_0_UART2_RX/PI_1_UART2_TX undefined error happen
Thanks