92
« on: November 24, 2008, 07:02:46 PM »
I just finished the simulator part of the tutorial and it all worked fine, after a few SP8 discrepancies were straightened out.
Now I am trying to get the target board, 52235evb, going, and I get LED1 blinking from the watchdog, and a few blinks of the ACT LED, but that is it. The ethernet doesn't appear to be getting started, or something. The link LED on the evb and on the hub are not lit.
I know my hardware is good, because it works with the Freescale software.
I'm using codewarrior 7.0 build 15
uTasker 1.3.0 SP8
I'm not even sure where to start looking.
Thanks for any help,
Aaron