Hi
If I have understood correctly, you have a non-uTasker based application and you convert it to a bin file using the conversion utility. Afterwards it is successfully loaded to the board. The board then reboots and copies the new code but then the board doesn't respond any more.
If this is the case, the boot loading was successful but the new program either doesn't run (linked to incorrect address for example or doesn't use interrupt vectors from RAM) or the new program doesn't support any Ethernet debug menu operation.
Don't forget that once you have downloaded new code, the original application (uTasker web server, debug menu etc. have been overwritten by your new code). It is up to your new code to supply everything that your new application requires, including the ability to download the next program.
I haven't heard of problems with SP6 and CW7. There are some potential issues with CW7 and SP7 (possibly same with SP6 but I never received reports of them) - these are listed here:
http://www.utasker.com/forum/index.php?topic=265.msg1123#msg1123Apart from a couple of manual set up changes there shouldn't be any problem with the application. The boot loader hasn't been tested by myself with CW7 and I plan to do this shortly - I have found that the code size increases with CW7 and am wondering whether it then won't fit into the allocated space...?
Regards
Mark